SIIG Serial ATA PCI-M
High-speed dual-channel PCI-to-Serial ATA host adapter for Power Mac systems
Part #: SC-SATM12
Model #: CN2523
Key Features and Benefits
- Supports two Serial ATA hard disk drives with high-speed data transfer rates up to 150MB/sec
- The thin, flexible Serial ATA cable is easier to route inside a PC
- Breaks the 137GB barrier! Supports various brands of large capacity Serial ATA hard disk drives. Note: Mac OS X v10.1 & v10.1.3 cannot see hard disk drives larger than 128GB. This is a limitation of the operating system
- Co-exists with onboard controller
- Can be used as the boot controller when a bootable hard disk drive is attached
- High quality SATA cable and 15-pin SATA power cable required for SATA hard disk installation are included!
Detailed Specs
- Version: v3.0
- Regulatory approval(s): FCC Class B (DoC) & C
- Port type: Two Serial ATA ports
- Slot type: 32-bit PCI
- Compliant with Serial ATA Specification, revision 1.0
- Compliant with PCI Specification, revision 2.2
- Co-exists with onboard controller and allows you to connect up to two Serial ATA hard disk drives
- Features independent 256-byte FIFOs per channel for host reads and writes
- Features Watch Dog timer for fault resiliency
- Supports 32-bit wide PCI bus at 66MHz and data transfer rates up to 150 MB/s (1.5Gb/s)
- Lower pin count and voltage requirement, plus better cabling over traditional Parallel ATA make Serial ATA the controller of the future
Compatible with:
- Requires Mac OS X 10.1 or later
- PowerMac G3 Blue & White Models
- All PowerMac G4 AGP Graphics/Sawtooth, Gigabit EtherNet, Digital Audio, Quicksilver, and Mirrored-Drive-Door Models
- All PowerMac G5 Models from 2003, 2004. 2005 Models that use PC3200 DDR Memory (Apple released new models in October 2005 that require PC4200 DDR2 Memory - these new 'DDR2' models do not have a compatible PCI Slot).
Package Contents
- (1) Serial ATA PCI-M adapter
- (1) Serial ATA cable
- (1) SATA 15-pin power cable
- (1) Quick Installation Guide
OWC NOTE: Update your SIIG SATA-M Card's Firmware HERE.
|