We're sorry, but this item is no longer for sale. However, there may be more Internal Hard Drives & SSDs items available.
4.0TB Micron 5100 ECO Series
SATA 2.5" SSD
Mfr P/N: MTFDDAK3T8TBY-1AR1ZABYY OWC SKU: MCRAK3T8TBY1A
Up to 540MB/s Read, 520MB/s Write
- Hot-plug capable (2.5-inch only)
- Native command queuing support with 32-command slot support
- ATA-8 ACS-3 revision 5 command set compliant
- Enhanced power-loss data protection with data protection capacitor monitoring
- Self-monitoring, analysis, and reporting technology (SMART) command set
- Secure field-upgradeable firmware with digitally signed firmware image
- 30 Day OWC Fulfilled Limited Warranty
Micron’s 5100 solid state drive (SSD) uses a single-chip controller with a SATA interface on the system side and four channels of Micron NAND Flash internally.
The SSD is designed to use the SATA interface efficiently during both READs and WRITEs while delivering bandwidth-focused performance. SSD technology enables enhanced boot times, faster application load times, reduced power consumption and extended reliability.
The self-encrypting drive (SED) features a AES-256 encryption engine, providing hardware-based, secure data encryption, with no loss of SSD performance. This SED follows the TCG Enterprise specification for trusted peripherals. When TCG Enterprise features are not enabled, the device can perform alternate data encryption by invoking the ATA security command set encryption features, to provide full disk encryption (FDE) managed in the host system BIOS. TCG Enterprise and ATA security feature sets cannot be enabled simultaneously.
The data encryption is always running; however, encryption keys are not managed and the data is not secure until either TCG Enterprise or ATA security feature sets are enabled.
Includes
- (1) Solid-state Drive
- 30 Day OWC Fulfilled Limited Warranty
Specs
Capacity
- 3840GB Useable Capacity
- Total Flash Memory Components: 4560GB
- 720GB Allocated to real-time data redundancy and error correction
Formatted Capacity
- 3576GiB
NAND Flash Components
- Micron Triple-Level Cell (TLC) 3D NAND Flash
S.M.A.R.T. Attributes
- Standard attributes supported
Native Command Queuing (NCQ)
- Up to 32 simultaneous commands
RAID Support
- No
Form Factor
- 2.5-inch 7mm
Storage Interface
- SATA 6.0 Gb/s
Random 4K Read
- Up to 93,000 IOPS
Random 4K Write
- Up to 18,000 IOPS
Sequential Read (Max)
- Up to 540 MB/s
Sequential Write (Max)
- Up to 520 MB/s
Sustained Read (3Gb/s)
- Up to 0 MB/s
Sustained Write (3Gb/s)
- Up to 0 MB/s
Sustained Read (6Gb/s)
- Up to 0 MB/s
Sustained Write (6Gb/s)
- Up to 0 MB/s
Read Latency (Max)
- 9 µs
Write Latency (Max)
- 5 µs
Nonrecoverable Read Errors
- 1 per 1017 bits read
MTBF (Mean Time Between Failures)
- 3,000,000 hours
TRIM Support
- Not Supported
Error Correction
- Built-in ECC
Security
- ATA Security Feature Command Set And Password Login Support
- Chip Based Data Encryption: 256-bit AES-compliant
Endurance
- 6400TB total bytes written (TBW)
Read Mode (Max)
- Up to 6 Watts
Write Mode (Max)
- Up to 6 Watts
Seek Mode (Max)
- Up to 0 Watts
Idle Mode (Max)
- Up to 1.5 Watts
Dimensions
- Height: 0.7 cm (0.3 in)
- Length: 10.1 cm (4.0 in)
- Width: 7.0 cm (2.7 in)
Weight
- 70.0 g (0.15 lbs)
RoHS Compliant
- Yes
Ambient Temperature
- Operating: 32°F to 158°F (0°C to 70°C)
- Non-Operating: -40°F to 185°F (-40°C to 85°C)
Altitude
- Operating: -304.8 m to 3,048.0 m (-1,000 ft to 10,000 ft)
- Non-Operating: -304.8 m to 12,192.0 m (-1,000 ft to 40,000 ft)
Humidity
- Operating: 5% to 95% non-condensing
Shock
- Non-Operating: 1500 G max at 0.5 ms
Idle (Typical)
- 0.0 bels
Seek (Typical)
- 0.0 bels